+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: Prints Sticking to the FEP Film (https://www.elegoomars.com/forum/forumdisplay.php?fid=12)
+--- Thread: Some prints stick to FEP. But not all... (/showthread.php?tid=1038)
Some prints stick to FEP. But not all... - LudoJ - 10-21-2021
Hi,
I have a weird behaviour with my saturn.
Some times, I have some prints that are not complete. Here is an example
[attachment=479]
All the prints on the bed are OK except for one that stopped in the middle.
FEP get clogged (this is after performing clean tank)
[attachment=480]
Is it the FEP which is already dead ? or a slicer issue ? Or something else.
[attachment=481]
I have done only 3 prints since I last changed the FEP (ok it was huge prints 20cm height)
How frequently do you change the FEP ?