+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Layer curling (/showthread.php?tid=636)
Layer curling - Dirty Kibbles - 09-24-2020
I am new to the resin printing and I just got an Elegoo Mars 2 Pro. I am trying to print a Settlers of Catan piece and running into the same fail (three times now). If I compared the failure to my filament printer, it looks like my build plate is too hot (obviously not what is going on here). I am using the Elegoo Rapid Resin (Grey). I am printing directly on the build plate and the slicer setting are attached below (The other settings were left unchanged). I have re-leveled the build plate and messed with the lift distance settings. I am not sure where to go next. Please help an newbie out!
RE: Layer curling - cliffyk - 09-25-2020
I would increase the exposure times by 50% (3 seconds and 50 seconds)--I know the Pro 2 is supposed to be faster, but 2 s seems awfully short...
RE: Layer curling - Dirty Kibbles - 10-01-2020
Thanks, Cliff! I appreciate your help and expertise. I will try to up the exposure time. Is upping the first layer necessary? That layer looks pretty perfect; it just looks like it starts to fail after that and at some point recovers itself.
RE: Layer curling - cliffyk - 10-01-2020
Try increasing just he main layers and see what you get. Determining practical exposure times is all trial and error...