12-30-2019, 12:01 AM
(This post was last modified: 12-30-2019, 12:03 AM by fromFDMtoSLA.)
just to say "Hello" from Germany
after 5 years of FDM-printing, i like to try "higher resolution, more precision, ... highttec ..."
my FDM's are doing still the job, but there was a good sales offer on eb** for a Elegoo Mars, i can NOT resist.
so, my FDM's: "say hello to your new colleague and do not talk shit about the smell and the build area ! - what about a layer of 0,01mm for your prints ?"
well the Mars is doing his job now, i am waiting for the water washable resin, ultrasonic cleaner and curing station are ready for post processing.
i found this forum by searching about infos and more about the Mars, in german 3d-printing forums, the SLA-printing is not so much present.
CU in 2020
after 5 years of FDM-printing, i like to try "higher resolution, more precision, ... highttec ..."
my FDM's are doing still the job, but there was a good sales offer on eb** for a Elegoo Mars, i can NOT resist.
so, my FDM's: "say hello to your new colleague and do not talk shit about the smell and the build area ! - what about a layer of 0,01mm for your prints ?"
well the Mars is doing his job now, i am waiting for the water washable resin, ultrasonic cleaner and curing station are ready for post processing.
i found this forum by searching about infos and more about the Mars, in german 3d-printing forums, the SLA-printing is not so much present.
CU in 2020