Elegoo 3D Printers Forum › Troubleshooting › Prints Sticking to the FEP Film v
Print on fep

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print on fep
admin Offline
Administrator
*******
Posts: 97
Threads: 8
Joined: Jul 2019
Reputation: 15
#4
08-20-2019, 11:43 PM
Okay, now do the supports print, but the actual piece being printed is not?

If so, that's usually related to not enough support contact to the model and the surface tension pulls it off the supports.
Find
Reply


Messages In This Thread
Print on fep - by caesar - 08-20-2019, 03:10 PM
RE: Print on fep - by admin - 08-20-2019, 05:34 PM
RE: Print on fep - by caesar - 08-20-2019, 10:50 PM
RE: Print on fep - by admin - 08-20-2019, 11:43 PM
RE: Print on fep - by caesar - 08-21-2019, 04:34 AM
RE: Print on fep - by admin - 09-05-2019, 01:06 AM
RE: Print on fep - by Big_D0093 - 09-13-2019, 07:28 PM
RE: Print on fep - by Spinnetti - 09-04-2019, 06:26 PM
RE: Print on fep - by caesar - 09-16-2019, 02:25 PM
RE: Print on fep - by flosen - 10-03-2019, 06:26 AM
RE: Print on fep - by caesar - 10-03-2019, 11:30 AM
RE: Print on fep - by flosen - 10-04-2019, 02:51 AM
RE: Print on fep - by caesar - 10-04-2019, 11:03 AM
RE: Print on fep - by flosen - 10-05-2019, 02:25 AM
RE: Print on fep - by caesar - 10-05-2019, 04:17 AM
RE: Print on fep - by flosen - 10-05-2019, 05:06 AM
RE: Print on fep - by caesar - 10-05-2019, 05:24 AM
RE: Print on fep - by ZX-Sinclair - 11-14-2019, 03:43 PM
RE: Print on fep - by ZX-Sinclair - 12-10-2019, 01:28 AM

Forum Jump:


Users browsing this thread: 5 Guest(s)