Elegoo 3D Printers Forum › Troubleshooting › Prints Sticking to the FEP Film v
Print on fep

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print on fep
caesar Offline
Junior Member
**
Posts: 14
Threads: 4
Joined: Jul 2019
Reputation: 0
#5
08-21-2019, 04:34 AM
(08-20-2019, 11:43 PM)admin Wrote: Okay,  now do the supports print, but the actual piece being printed is not? 

If so, that's usually related to not enough support contact to the model and the surface tension pulls it off the supports.
No, supports is not printed, nothing.

The base is partially printed, but on the fep
Find
Reply


Messages In This Thread
Print on fep - by caesar - 08-20-2019, 03:10 PM
RE: Print on fep - by admin - 08-20-2019, 05:34 PM
RE: Print on fep - by caesar - 08-20-2019, 10:50 PM
RE: Print on fep - by admin - 08-20-2019, 11:43 PM
RE: Print on fep - by caesar - 08-21-2019, 04:34 AM
RE: Print on fep - by admin - 09-05-2019, 01:06 AM
RE: Print on fep - by Big_D0093 - 09-13-2019, 07:28 PM
RE: Print on fep - by Spinnetti - 09-04-2019, 06:26 PM
RE: Print on fep - by caesar - 09-16-2019, 02:25 PM
RE: Print on fep - by flosen - 10-03-2019, 06:26 AM
RE: Print on fep - by caesar - 10-03-2019, 11:30 AM
RE: Print on fep - by flosen - 10-04-2019, 02:51 AM
RE: Print on fep - by caesar - 10-04-2019, 11:03 AM
RE: Print on fep - by flosen - 10-05-2019, 02:25 AM
RE: Print on fep - by caesar - 10-05-2019, 04:17 AM
RE: Print on fep - by flosen - 10-05-2019, 05:06 AM
RE: Print on fep - by caesar - 10-05-2019, 05:24 AM
RE: Print on fep - by ZX-Sinclair - 11-14-2019, 03:43 PM
RE: Print on fep - by ZX-Sinclair - 12-10-2019, 01:28 AM

Forum Jump:


Users browsing this thread: 7 Guest(s)