First post here and very new to 3D printing so be kind if I'm making a total plonker out of myself 
I bought and received my Mars right about the time we locked down so couldn't get hold of supplies for ages. Finally got what I needed so thought I'd fire this bad boy up and get printing.
I followed all of the instructions in the manual. My first test print of the two rooks produced half a print and a perfect print. The one that worked was absolutely perfect. I cleaned up and thought I'd try again. This time I got nothing at all. Nothing printed. I figured I might have done something wrong so reset and tried again and that time all I got was two very thin discs
So I went back to the manual and did all of the setup tests again. This time the exposure test completely failed. No rectangle. Nothing except faint lights under the print area.
Pretty gutted at this stage, especially with all the cleaning required.
Can anyone tell me what I might be doing wrong or what might be the problem? Thanks
I bought and received my Mars right about the time we locked down so couldn't get hold of supplies for ages. Finally got what I needed so thought I'd fire this bad boy up and get printing.
I followed all of the instructions in the manual. My first test print of the two rooks produced half a print and a perfect print. The one that worked was absolutely perfect. I cleaned up and thought I'd try again. This time I got nothing at all. Nothing printed. I figured I might have done something wrong so reset and tried again and that time all I got was two very thin discs
So I went back to the manual and did all of the setup tests again. This time the exposure test completely failed. No rectangle. Nothing except faint lights under the print area.
Pretty gutted at this stage, especially with all the cleaning required.
Can anyone tell me what I might be doing wrong or what might be the problem? Thanks