10-01-2020, 07:35 AM
Thanks, the holes on the actual part go through that section so suction is not an issue. The picture is of my test piece which I admit has not got vent holes.
The problem I have is that the first layers are sealing over the holes as the elephant's foot effect is too large. The smallest holes are 0.75mm but even with a 1mm chamfer, the hole is still closed over.
If I can get even a pinhole in the face, I can run a drill through to clean it up but I can't if it's solid as I can't be sure of its position.
Anybody got some settings they use?
PS: I'm using Prusa Slicer.
Thanks
Jason
The problem I have is that the first layers are sealing over the holes as the elephant's foot effect is too large. The smallest holes are 0.75mm but even with a 1mm chamfer, the hole is still closed over.
If I can get even a pinhole in the face, I can run a drill through to clean it up but I can't if it's solid as I can't be sure of its position.
Anybody got some settings they use?
PS: I'm using Prusa Slicer.
Thanks
Jason