(10-01-2020, 04:00 PM)cliffyk Wrote: Don't be concerned, it is normal. A way to minimise it is to polish the scraper's edge with some fine (220 to 400 grit) wet/dry sane paper. I ground the end of mine to at 30° or so single edged bevel and the polished it up with 320 grit paper leaving a very slight radius on the non-beveled edge. Round off the corners to a slight radius and polish them as well. Use the non-bevel edge against the platen and beveled edge to slip under the print.
What exposures did youi use with the semi-clear resin? Opaque resins require longer exposures, the darker the longer...
I didn't adjust anything. It was still the same exposure. I believe it said the first x amount of layers were 50 and the rest were 6. Same as what I used on the grey and it just worked for some reason.