10-02-2020, 07:08 PM
Okay so I had another successful print with the clear resin. I then tried a new Elegoo ABS-like Grey resin and it failed. I added in some supports for the model I was attempting and the supports printed fine but again the base of the model only seemed to print maybe a couple layers. It was paper thin and stuck to the film so I cancelled the project. I am attempting a different model and I've increased the exposure time from 6 to 10 and the bottom exposure time from 50 to 75. I am going to see if this makes any difference. It seems the issue with the grey keeps being the larger bases aren't attached to the plate yet the smaller support bases are...? Again I haven't tested this model in clear so maybe I should have tried the rook again.. but I guess we will see what happens.