09-05-2019, 01:06 AM
(08-21-2019, 04:34 AM)caesar Wrote:(08-20-2019, 11:43 PM)admin Wrote: Okay, now do the supports print, but the actual piece being printed is not?No, supports is not printed, nothing.
If so, that's usually related to not enough support contact to the model and the surface tension pulls it off the supports.
The base is partially printed, but on the fep
Yea, sounds like a bed leveling issue, but perhaps could be settings related as well. What do you have set for exposure times and base layers?
a good rule of thumb for settings, regardless of the resin color would be the following...
Layer Height: 0.05
Bottom Layer Count: 8
Exposure Time: 10
Bottom Exposure Time: 60