09-13-2019, 07:28 PM
(08-21-2019, 04:34 AM)caesar Wrote:What resin are you using? I had the same problem when I first got my mars printer and it turned out that the resin wasn't working no matter what my settings were, so I used the Anycubic basic grey resin and haven't had a failure since. It may be the same problem for you, I don't know just trying to help from my bad experience.(08-20-2019, 11:43 PM)admin Wrote: Okay, now do the supports print, but the actual piece being printed is not?No, supports is not printed, nothing.
If so, that's usually related to not enough support contact to the model and the surface tension pulls it off the supports.
The base is partially printed, but on the fep