Hi all, I’m new to 3d printing… got the elegoo mars 2 pro for Christmas and only just done the rook test print.
Everything went smoothly and got two rooks
but… there seems to be a little flaking and not sure what would have caused it. No other issues visible.
I used the test as is (probably the issue) so whatever settings it had baked in. The resin I used was the grey elegoo water washable rapid resin.
I’ve attached a picture and look forward to hearing from you all.
Many thanks (happy new year)
Muzzy
Everything went smoothly and got two rooks
but… there seems to be a little flaking and not sure what would have caused it. No other issues visible.I used the test as is (probably the issue) so whatever settings it had baked in. The resin I used was the grey elegoo water washable rapid resin.
I’ve attached a picture and look forward to hearing from you all.
Many thanks (happy new year)
Muzzy