02-08-2022, 04:23 PM
That is exactly how I do it...
However the needed correction will be affected by overall volume and relative X, Y, Z dimensions as the "tiny mushy bricks" pile up--any "average" correction will be just a good place to start based on experience and what your gut tells you.
Keep in mind that while the Z-axis resolution for your Saturn is variable in 0.00125 mm (1.25 micron) increments via layer height, X & Y maximum resolution is fixed by the LCD pixel size (0.05 mm, 50 microns).
Actual print dimensions (even if 100% accurate) will always be multiples of those maximum resolutions.
Keep in touch and let us know how things are going...
However the needed correction will be affected by overall volume and relative X, Y, Z dimensions as the "tiny mushy bricks" pile up--any "average" correction will be just a good place to start based on experience and what your gut tells you.
Keep in mind that while the Z-axis resolution for your Saturn is variable in 0.00125 mm (1.25 micron) increments via layer height, X & Y maximum resolution is fixed by the LCD pixel size (0.05 mm, 50 microns).
Actual print dimensions (even if 100% accurate) will always be multiples of those maximum resolutions.
Keep in touch and let us know how things are going...
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)