Print on fep

[caesar]

Thanks. 
Problem solved, it was all a question of supports and timing, perfect printing. ELEGOO BLACK resin

Could you share your settings please?

I keep having the exact same issue. All I get in a dozen tries now is a silhouette, a few layers thick, on the FEP. The very first try went well. But then I tried to print the same thing again and it never worked again. Tried to increase and decrease bottom layers, exposure time and layer height. Changed the angle of the piece to print, used more or less supports. Even replaced the FEP already (after one working print!  ). I re-calibrated the platform. Nothing gets me any working prints. I'm using Elegoo black resin for the first as well as all failed prints. I'm really out of ideas and frustrated.
Thanks for any suggestions you might have.

Remember to place the build platform correctly