Elegoo 3D Printers Forum › Troubleshooting › Prints Sticking to the FEP Film v
Print on fep

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print on fep
flosen Offline
Junior Member
**
Posts: 4
Threads: 0
Joined: Oct 2019
Reputation: 0
#12
10-04-2019, 02:51 AM
(10-03-2019, 11:30 AM)caesar Wrote: Remember to place the build platform correctly

I straightened it as described in the manual for my first print, the only one that has been working so far. That went well and I didnt touch it for the second and third, which didnt work. Then I repeated the process again, loose the screws, move down the platform, tighten the screws. Still not working.
Is there anything else to take into account other than these two screws for X and Y axis as described in the manual in terms of platform placing? As far as I can tell there is no Z axis calibration, right?
Find
Reply


Messages In This Thread
Print on fep - by caesar - 08-20-2019, 03:10 PM
RE: Print on fep - by admin - 08-20-2019, 05:34 PM
RE: Print on fep - by caesar - 08-20-2019, 10:50 PM
RE: Print on fep - by admin - 08-20-2019, 11:43 PM
RE: Print on fep - by caesar - 08-21-2019, 04:34 AM
RE: Print on fep - by admin - 09-05-2019, 01:06 AM
RE: Print on fep - by Big_D0093 - 09-13-2019, 07:28 PM
RE: Print on fep - by Spinnetti - 09-04-2019, 06:26 PM
RE: Print on fep - by caesar - 09-16-2019, 02:25 PM
RE: Print on fep - by flosen - 10-03-2019, 06:26 AM
RE: Print on fep - by caesar - 10-03-2019, 11:30 AM
RE: Print on fep - by flosen - 10-04-2019, 02:51 AM
RE: Print on fep - by caesar - 10-04-2019, 11:03 AM
RE: Print on fep - by flosen - 10-05-2019, 02:25 AM
RE: Print on fep - by caesar - 10-05-2019, 04:17 AM
RE: Print on fep - by flosen - 10-05-2019, 05:06 AM
RE: Print on fep - by caesar - 10-05-2019, 05:24 AM
RE: Print on fep - by ZX-Sinclair - 11-14-2019, 03:43 PM
RE: Print on fep - by ZX-Sinclair - 12-10-2019, 01:28 AM

Forum Jump:


Users browsing this thread: 4 Guest(s)