10-05-2019, 05:24 AM
(10-05-2019, 05:06 AM)flosen Wrote:(10-05-2019, 04:17 AM)caesar Wrote: Between the resin tank and the lcd glass did you put some too thick protection, adhesive tape, a fep sheet?
For calibration I put a thin sheet of paper. For printing there is nothing except that one layer of FEP that is the bottom of the tank.
(10-05-2019, 04:17 AM)caesar Wrote: Does fep on resin tank have the right tension?
I would assume at least since the very first print did work and the FEP or its tension didnt change for a few more tries, that all failed then. But anyway, what would be more likely to have prints stick to the FEP? Too much or too little tension of the FEP? At least I could try to improve the situation then by tightening or loosening it.
Without a doubt the fep on the resin tank must be stretched not "elastic".
it is possible that you have to build adequate supports with attention to the surface at the base from which the supports are developed.