Prints sticking to resin vat bottom
|
Prints sticking to resin vat bottom
|
10-10-2019, 01:24 AM
If it's just a ring and the side on the build plate has less surface area then say the middle, then theres not enough surface area on the build plate that is equal to, or greater then the biggest area.
You want to have more surface area attached to the build plate, so adding supports will help greatly. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Prints sticking to resin vat bottom - by Pixacor - 09-28-2019, 09:42 AM
RE: Prints sticking to resin vat bottom - by Pixacor - 09-28-2019, 11:56 AM
RE: Prints sticking to resin vat bottom - by caesar - 10-04-2019, 11:09 AM
RE: Prints sticking to resin vat bottom - by admin - 10-10-2019, 01:24 AM
RE: Prints sticking to resin vat bottom - by Marwer - 10-19-2019, 06:57 PM
RE: Prints sticking to resin vat bottom - by nico940 - 10-21-2019, 02:48 PM
RE: Prints sticking to resin vat bottom - by Prints Charming - 10-28-2019, 05:10 AM
RE: Prints sticking to resin vat bottom - by nico940 - 10-29-2019, 02:50 AM
RE: Prints sticking to resin vat bottom - by Ewok - 12-06-2019, 12:44 PM
RE: Prints sticking to resin vat bottom - by TristanA - 03-15-2020, 12:54 AM
|
