11-14-2019, 03:43 PM
I have exactly the same problem.
The Mars had never printed one thing. Only the first layers on the FEP.
I levelled several times. I treated the FEP with RainX (hint from the forum).
Chitubox sliced not with default, but with Elegoo Mars.
The time for the first layer is up to 90sec!
Resin from Anycubic
I checked the film, the screws, tank, everything.
Nothing works!
Any ideas?
The Mars had never printed one thing. Only the first layers on the FEP.
I levelled several times. I treated the FEP with RainX (hint from the forum).
Chitubox sliced not with default, but with Elegoo Mars.
The time for the first layer is up to 90sec!
Resin from Anycubic
I checked the film, the screws, tank, everything.
Nothing works!
Any ideas?