11-17-2019, 03:22 PM
(This post was last modified: 11-17-2019, 03:23 PM by defiantworkshop.)
Count me in the group frustrated about this. I've upped the thickness of my supports, fluctuated between 1.5mm and 3mm supports. I've bounced between 8-16 second cure times. I've never had a failed print with my gray resin with normal (1.5mm supports, 10 second cure time) settings, and a 90-95% success rate with my transparent green resin. I've thus far had a 0% success rate with the clear, and my bottle is almost empty. My supports look like a post apocalyptic wasteland when the print is done...the vast majority of the supports just stop forming at some point. Some of them extend the whole way up, an some just never work right to begin with. At this point I've spent approx $15 on failed prints alone on this, so I'm desperate to get some use out of what little I have left. Anyone have some pointers?