01-06-2020, 11:37 AM
What about the test exposure rectangle? Does it seem okay? Already Cleaned the printbed with some ipa or something... Maybe there are some fingerprints, grease on it?
Elegoo 3D Printers Forum
›
Troubleshooting
›
Prints Sticking to the FEP Film
Nothing sticks to the left side of the print bed
Nothing sticks to the left side of the print bed
|
Nothing sticks to the left side of the print bed
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Nothing sticks to the left side of the print bed - by morgan164 - 01-05-2020, 11:27 AM
RE: Nothing sticks to the left side of the print bed - by VDX - 01-05-2020, 12:34 PM
RE: Nothing sticks to the left side of the print bed - by Marsianer - 01-06-2020, 11:37 AM
RE: Nothing sticks to the left side of the print bed - by morgan164 - 01-07-2020, 11:54 PM
|
Users browsing this thread: 1 Guest(s)