01-25-2020, 01:37 AM
(01-01-2020, 04:32 PM)Peter F Wrote:(01-01-2020, 03:01 PM)VDX Wrote: ... maybe inch/mm confusion?I tested this using Cura and had the same problem. It turns out this is a common problem
Viktor
I designed the part in inches, but apparently STL Files don’t contain unit information. Most slicing programs are expecting the file to be in mm’s so as a result the file comes in 25.4 times smaller.
i know abot the problem from FDM-printing. so i scaled the models up by the factor of 25.4 in each axis